Our Owasso crew pulls the idle tub, keeps the alcove, and hands back a shower anywhere in Tulsa County within days.
Written quote at no cost, one callback, no chasing afterwards.
Maybe you are tired of stepping over that high, dangerous ledge every single morning just to wash off the sleep.
Actually, swapping out that clunky old deep basin for a walk-in stall makes your daily routine so much safer and faster.
Our local crew specializes in this exact swap to make your life easier.
Naturally, you want to know how much this upgrade will cost before making any big plans.
That is why we offer a completely free in-home estimate to help you plan your budget without any pressure.
Simply fill out our quick form to get your custom price quote today!
First of all, you get so much more actual room to move around when you get rid of that dusty old basin.
Which means you will not be bumping your elbows against cold plastic walls anymore when you try to wash your hair.
Instead, you enjoy a spacious layout that fits your body comfortably.
On top of that, safety becomes a major plus because you no longer have to balance on one wet foot to climb inside.
As a matter of fact, slips and trips happen way too often in older bathrooms with high thresholds.
This simple home remodel eliminates that hazard entirely by keeping the entry point nice and low to the ground.
To give you a better idea of how these two setups compare, we put together a handy little guide.
This table highlights the main differences our customers notice after we finish the job.
| Feature | Old Deep Basin Setup | Modern Low-Step Stall |
|---|---|---|
| Entry Height | Usually 15 to 18 inches high | Only 3 to 5 inches high |
| Floor Space | Narrow and curved bottom | Wide, flat, and slip-resistant |
| Cleaning Time | Hard to scrub corners | Sleek walls wipe down fast |
So, you might wonder if this project really boosts the actual value of your family home.
Yes, it absolutely does because most modern buyers prefer a sleek, fast-access setup over a dusty soaking basin they will never use.
This means your property instantly appeals to a much wider crowd of potential buyers if you ever decide to sell.
Besides the financial side, think about how much easier it is to keep a flat-pan stall sparkling clean.
For example, we use high-quality acrylic walls that naturally resist mold, mildew, and stubborn soap scum buildup.
This lets you spend your weekends relaxing rather than scrubbing grout lines on your hands and knees.
Furthermore, you can customize the whole look with modern fixtures, built-in benches, and handy corner shelves.
Which means everything you need for your morning routine stays right at arm's reach.
You get a beautiful, organized space that feels like a private spa retreat.
Now, let us talk about how we actually get this work done without turning your house into a giant mess.
First, we carefully protect your flooring with heavy drop cloths before we touch a single tool.
Then, our crew removes the old heavy cast iron or fiberglass basin without damaging your existing walls.
After that, we inspect the wood framing underneath to ensure there is no hidden water damage or rot.
If we find any soft spots, we repair them immediately so your new stall sits on a rock-solid foundation.
This extra step prevents future sag and keeps your home safe from hidden leaks.
Finally, we install the brand-new plumbing lines, the sturdy low-profile pan, and the gorgeous waterproof wall panels.
Because we plan every step ahead of time, we usually wrap up the whole installation in just a few days.
This speed keeps your daily routine running smoothly with very little disruption.
To start, you get to choose from a wide variety of wall textures and colors that match your style.
Whether you love the classic look of subway tile or the rich appearance of natural stone, we have options for you.
These panels look identical to real tile but require zero annoying grout maintenance.
Additionally, we can install heavy-duty grab bars that blend beautifully into the overall design.
This ensures you have extra support whenever you need it without making the space look like a hospital room.
Safety and style can easily go hand in hand.
Another big decision involves choosing between a classic sliding glass door or a modern frameless glass panel.
Sliding doors work wonderfully if you have a tight bathroom where space is at a premium.
On the flip side, a frameless panel offers a stunning, open feel that makes the entire room look twice as big.
Whichever style you choose, we use thick tempered safety glass that handles daily wear and tear with ease.
This durable glass also features a special protective coating that repels water spots and soap film.
Your bathroom keeps that clean, bright shine with just a quick wipe after you finish washing.
Honestly, we love driving our work trucks through the beautiful streets of this growing green country community.
We know the local neighborhoods well, from the quiet residential areas near the high school to the bustling shopping spots.
Our team feels like family here, and we treat your home with the exact same respect.
With a local population of 35,646 people, we have helped many of your neighbors upgrade their homes already.
Since the median household income sits around $72,930, we know that local families value smart, durable investments.
We make sure every dollar you spend on your home remodel delivers maximum durability and daily enjoyment.
Whether you live right in the heart of Tulsa County or in the 74055 ZIP code area, we are just a quick drive away.
Because we are local, we understand the specific water conditions and building codes unique to this part of Oklahoma.
This local knowledge ensures your plumbing upgrades are always done perfectly the very first time.
If you are ready to stop struggling with that old, outdated basin, we are here to help you make a change.
Our friendly team will come directly to your home, measure your space, and give you a detailed plan.
You will see exactly how we can transform your bathroom into a safer, more modern space.
Remember, our custom quotes are completely free of charge and carry absolutely no obligation to buy.
This lets you explore your options, ask all your questions, and make the best decision for your family.
Contact us today to schedule your visit and take the first step toward a better morning routine!
Count the baths your household actually ran last year. In most homes we visit, the honest number is somewhere between zero and three, and yet every single morning somebody swings a leg over fifteen inches of porcelain rim to stand up and shower inside a fixture built for lying down. The tub charges rent daily and works a few evenings a year.
Nothing dramatic follows from that. Nobody is in danger because a bathtub exists, and if long soaks are part of your week, keep the tub and enjoy it with our blessing. The case for the conversion is plainer: when the tub has become a shower tray with high sides, you are paying, in caution and in cleaning, for a feature you retired years ago.
The swap itself is smaller than most people picture. The supply lines, the drain and the alcove walls are already exactly where a shower wants them, which is why this is a job measured in days. We are not building a new bathroom; we are letting the one you have stop pretending it still gives baths.
The same alcove, photographed the way the week actually unfolds. Weather never delays this one; it all happens indoors.
Floors along the hallway get covered, the water goes off for a few hours, and the bathtub is cut free and carried out, tile flange and all. With the alcove stripped, the plumber moves the drain to where the new pan wants it and sets the new valve at shower height. By supper the room is bare, clean and ready.
The base arrives first: an acrylic pan set dead level on a mortar bed, or a sloped, waterproofed floor when the plan says curbless. Then the walls close in, either grout-free panels bonded in a single afternoon or backer board ready for tile. Everything from here on is watertight before it is pretty.
The glass panel or door is drilled, hung and plumbed straight, the trim goes on, and the silicone lines are drawn last. Silicone wants a day to cure, so the first shower usually happens the following morning, which is exactly how we schedule the walkthrough.
Both are real showers in the same alcove. The difference is the entry, and what has to happen under it.
| What you weigh | Low curb | Curbless |
|---|---|---|
| What stands at the entry | A tidy threshold about 3 to 4 inches tall | Nothing. The bathroom floor rolls straight into the shower |
| Cost, installed | The friendlier bracket, most jobs land here | Roughly a third to a half more, the floor is rebuilt |
| What the crew rebuilds | The alcove only; the bathroom floor stays shut | Part of the bathroom floor, sloped and waterproofed |
| Water containment | The curb and glass do the holding | The slope and a linear drain do the holding |
| Suits best | Straight swaps on a budget and upstairs bathrooms | Wheels, walkers, and anyone planning to stay put for decades |
Undecided is a fine answer on the form. The site visit settles it with a tape measure, not a sales pitch.
Removal
Cut free, hauled out and off to recycling, with floors and doorways shielded on the way. The loudest hour of the conversion, and it wraps before most jobs have begun.
Plumbing
Tub drains sit at one end; showers drain where the pan says. We move what needs moving and swap the old valve for a pressure-balanced one.
The base
A level acrylic pan for most swaps, a mortar-built sloped floor for curbless plans. Either way it is tested with water before anything covers it.
The walls
Grout-free panels go up in an afternoon and wipe clean forever. Tile takes longer, costs more, and looks like whatever you can imagine.
The glass
A fixed panel keeps things open and easy to clean; a hinged door closes the warmth in. Both are tempered, both are set dead straight.
The finish
Shelving, the hand shower, clean caulk lines and a walkthrough. We leave the cure time in writing so the first shower is not a gamble.
| The job | Usual range | Inside the number |
|---|---|---|
| Standard tub-to-shower conversion | $3,100 - $5,600 | Tub out, low curb pan, wall panels, new valve, glass panel. |
| Curbless conversion | $4,900 - $8,800 | The floor is rebuilt flush and sloped to a linear drain. |
| Glass: fixed panel or hinged door | $450 - $1,400 | A single panel sits at the low end, a framed door at the top. |
| Walls: PVC panels or tile | $1,100 - $3,900 | Panels finish in a day; tile adds days and takes any look you want. |
| Tear-out only | $450 - $950 | The tub gone and the alcove left clean for another trade. |
| Small job minimum | around $2,400 | Even the simplest swap books a licensed plumber and a full crew. |
Wall condition, drain position and the glass you choose move every line. The visit pins the figure down, and the figure then holds.
A bathtub drains at one end through its own trap; most showers want the drain nearer the middle, or along one edge when the plan is curbless. Sometimes the existing trap is close enough to reuse and sometimes it has to travel a foot or two, which means opening a strip of floor. We can usually tell which from the basement or the crawl space during the visit, and the paperwork you sign already names which one you are getting.
Houses older than the seventies like to add a surprise: galvanized supply lines rusted nearly shut, a cast iron trap that crumbles at a touch, or framing that got damp decades ago and kept it quiet. None of it is rare and none of it is ruinous, but it is your call, not ours. When something like that turns up, work pauses, you get photographs and a price for the fix, and nothing is billed until you have said yes to it. A conversion should never be the job where the invoice writes itself.
QIs losing the only bathtub a resale mistake?
AAgents around Owasso repeat one rule: a family house shows better with a tub somewhere in it. If this is your only tub and small children are in your plans, we put that on the table during the visit and you decide with open eyes. If another bathroom keeps its tub, or the buyers you expect are shower people, the argument evaporates.
QHow long do we go without washing?
AThe toilet and sink stay usable every evening, and the water is only off for stretches on day one. The shower itself is ready once the silicone cures, so figure on missing roughly three days of showers at home. Plenty of clients time the job before a weekend away.
QDoes all the old tile come off the walls?
AOn the alcove walls, yes, because the new waterproofing needs to start from the studs, not from forty-year-old grout. Tile outside the alcove stays put, and we cut a clean line where the two meet.
QCan the new shower use the tub drain?
AThe pipe itself is nearly always reusable; the position is the question. A low curb pan can often sit its drain within reach of the old trap. Curbless floors want a relocated or linear drain, and that difference is priced before demo, never discovered after.
QDo we need a permit for the swap?
AA like-for-like fixture swap usually rides on a simple plumbing permit, and moving the drain can add an inspection. We file whatever your jurisdiction wants and fold the cost into the written price.
QWhat if there is rot behind the tub?
AIt happens, mostly around the old tile flange. You get photographs the hour we find it, a firm price for the repair, and the choice to proceed or pause. The framing fix is usually a morning, not a remodel.
The map carries the geography; the link lists underneath spell out every town our crews can reach from this one.
For the bigger map: county seat pages start at Tulsa County; the statewide picture lives on Oklahoma; the wider region is the South; background reading sits on Wikipedia.
One three-day job stands between this bathroom and its best fixture.
Get my free quote