Across Scioto County, bathtubs that retired years ago give way to showers built in their own footprint.
Written quote at no cost, one callback, no chasing afterwards.
Swapping your old soaking basin for a fresh walk-in enclosure makes your everyday morning routine way easier and safer. You get instant room to move around without tripping over high edges every single day.
First, removing that bulky basin clears up so much floor space in a tight washroom. Honestly, my cousin tried stepping over her tall tub wall last year and almost ended up in the hospital, which totally freaked us all out... Since then, switching to a flat entry base just makes complete sense for keeping everybody safe. On top of that, taking out old porcelain units gets rid of hidden mold pockets that build up behind dusty walls over time.
Additionally, modern acrylic walls wipe down in like two minutes with a basic sponge. Next, you can kiss those gross, slimy curtain rings goodbye for good. Furthermore, a custom glass door setup adds serious value and maximum coziness to your entire house without needing a full home remodel.
Granted, traditional soaking tubs sound nice on paper until you actually have to clean them on your hands and knees. Consequently, most busy folks barely use them for long soaks anyway. Meanwhile, an updated walk-in area gives you quick access when you are rushing to get ready for work.
Naturally, our southern corner of the Buckeye State features many cozy older homes built decades ago. Because these vintage houses have smaller washrooms, maximizing every square inch becomes super important for comfort. Therefore, replacing an unused basin creates a surprisingly open feel even in tiny layouts.
Besides, retrofitting your splash zone improves daily home life for every family member. For instance, kids and grandparents alike can step inside without stretching or slipping on slick porcelain. Actually, adding built-in seating or sturdy grab bars makes it even better for long-term accessibility.
| Old Basin Setup | Modern Walk-In Barrier |
|---|---|
| High step-over ledge causing trip hazards | Low threshold for simple stepping |
| Difficult corners that trap thick soap scum | Smooth water-resistant panels that wipe clean easily |
| Clunky fabric curtains that hold moisture | Sleek glass doors that keep water inside |
Clearly, looking at the direct benefits helps you see why so many neighbors are changing their setups. Ultimately, getting rid of outdated fixtures lets you build a personalized space that fits your modern schedule.
Initially, our local team comes right to your door to measure your current space up to the exact millimeter. Right after that, we talk about your favorite styles, panel textures, and heavy-duty fixtures. Plus, getting a clear estimate costs you absolutely nothing at all upfront.
Subsequently, expert crews tear out the original heavy unit while protecting your subfloor from lingering wetness. Afterwards, we update old plumbing valves so your water pressure stays blazing strong. As a result, your new enclosure performs perfectly for many years down the road without sneaky leaks.
Usually, the actual physical installation takes just a day or two once materials arrive. Soon, you are enjoying high-end refinement without waiting weeks for messy construction workers to finish. Afterwards, our crew cleans up every single piece of debris so your house stays spotless.
To begin with, thousands of local residents across regional towns like Portsmouth, Wheelersburg, and New Boston deserve reliable home updates. Furthermore, with local median household incomes floating around forty-eight thousand dollars, getting real value out of home improvements matters immensely. Also, property owners across ZIP codes ranging from 45662 to 45694 want durable upgrades that do not break their bank accounts.
Interestingly, regional census data counts roughly seventy-four thousand neighbors living in this scenic river valley county. Therefore, upgrading older housing stock keeps local neighborhoods strong and valuable. Consequently, making smart home investments now protects your house value for the future.
Basically, modern walk-in enclosures offer incredible options for every individual taste. Conveniently, you can add sleek corner caddies to hold all your shampoos and body washes effortlessly. Additionally, slip-resistant flooring textures keep your feet planted firmly, even when things get super soapy.
Now, installing directional jet heads gives you a spa-like feel right inside your own home. Also, stylish hand-held wands make rinsing off walls or washing pets totally painless. In short, these small custom tweaks completely transform how your room functions daily.
Obviously, home buyers today actively look for modern, low-maintenance washrooms when shopping around. Hence, removing an ancient dated basin often helps your property sell much faster on the market. Furthermore, buyers love seeing durable acrylic surfaces that look brand new without extra work.
Simultaneously, you save tons of precious time every weekend because cleaning becomes a total breeze. Instead of scrubbing stained grout lines for hours, you just spray and wipe smoothly. Truly, that extra free time is worth every single penny spent on the upgrade.
Now, some folks worry that removing a tub might hurt their property value if families move in. However, most modern buyers actually prefer having a large, stylish walk-in splash space over an old tub they will never fill up. Besides, as long as your home keeps at least one basin elsewhere, your market value stays totally solid.
Likewise, people sometimes worry about long construction delays ruining their household routine. Luckily, modern installation methods eliminate dusty demolition work that drags on for weeks. Therefore, your daily family life gets back to normal almost instantly.
First, taking the very first step toward a updated space is completely stress-free and easy. Simply contact our team today to setup your zero-cost home consultation whenever you are free. Straightforwardly, we walk through every option together so you get the exact layout you want.
Second, our local installers inspect your current setup to catch potential plumbing issues early on. This way, you avoid surprising costs or hidden structural problems halfway through the job. On top of that, our transparent pricing ensures you know exactly what to expect.
Finally, upgrading your morning routine brings real everyday pleasure and simple convenience to your household. Why keep struggling with a risky, hard-to-clean setup when a fresh setup is so accessible? So, grab your completely free quote today and start planning your perfect home upgrade right now!
Count the baths your household actually ran last year. In most homes we visit, the honest number is somewhere between zero and three, and yet every single morning somebody swings a leg over fifteen inches of porcelain rim to stand up and shower inside a fixture built for lying down. The tub charges rent daily and works a few evenings a year.
Nothing dramatic follows from that. Nobody is in danger because a bathtub exists, and if long soaks are part of your week, keep the tub and enjoy it with our blessing. The case for the conversion is plainer: when the tub has become a shower tray with high sides, you are paying, in caution and in cleaning, for a feature you retired years ago.
The swap itself is smaller than most people picture. The supply lines, the drain and the alcove walls are already exactly where a shower wants them, which is why this is a job measured in days. We are not building a new bathroom; we are letting the one you have stop pretending it still gives baths.
The same alcove, photographed the way the week actually unfolds. Weather never delays this one; it all happens indoors.
Floors along the hallway get covered, the water goes off for a few hours, and the bathtub is cut free and carried out, tile flange and all. With the alcove stripped, the plumber moves the drain to where the new pan wants it and sets the new valve at shower height. By supper the room is bare, clean and ready.
The base arrives first: an acrylic pan set dead level on a mortar bed, or a sloped, waterproofed floor when the plan says curbless. Then the walls close in, either grout-free panels bonded in a single afternoon or backer board ready for tile. Everything from here on is watertight before it is pretty.
The glass panel or door is drilled, hung and plumbed straight, the trim goes on, and the silicone lines are drawn last. Silicone wants a day to cure, so the first shower usually happens the following morning, which is exactly how we schedule the walkthrough.
Both are real showers in the same alcove. The difference is the entry, and what has to happen under it.
| What you weigh | Low curb | Curbless |
|---|---|---|
| What stands at the entry | A tidy threshold about 3 to 4 inches tall | Nothing. The bathroom floor rolls straight into the shower |
| Cost, installed | The friendlier bracket, most jobs land here | Roughly a third to a half more, the floor is rebuilt |
| What the crew rebuilds | The alcove only; the bathroom floor stays shut | Part of the bathroom floor, sloped and waterproofed |
| Water containment | The curb and glass do the holding | The slope and a linear drain do the holding |
| Suits best | Straight swaps on a budget and upstairs bathrooms | Wheels, walkers, and anyone planning to stay put for decades |
Undecided is a fine answer on the form. The site visit settles it with a tape measure, not a sales pitch.
Removal
Cut free, hauled out and off to recycling, with floors and doorways shielded on the way. The loudest hour of the conversion, and it wraps before most jobs have begun.
Plumbing
Tub drains sit at one end; showers drain where the pan says. We move what needs moving and swap the old valve for a pressure-balanced one.
The base
A level acrylic pan for most swaps, a mortar-built sloped floor for curbless plans. Either way it is tested with water before anything covers it.
The walls
Grout-free panels go up in an afternoon and wipe clean forever. Tile takes longer, costs more, and looks like whatever you can imagine.
The glass
A fixed panel keeps things open and easy to clean; a hinged door closes the warmth in. Both are tempered, both are set dead straight.
The finish
Shelving, the hand shower, clean caulk lines and a walkthrough. We leave the cure time in writing so the first shower is not a gamble.
| The job | Usual range | Inside the number |
|---|---|---|
| Standard tub-to-shower conversion | $3,100 - $5,600 | Tub out, low curb pan, wall panels, new valve, glass panel. |
| Curbless conversion | $4,900 - $8,800 | The floor is rebuilt flush and sloped to a linear drain. |
| Glass: fixed panel or hinged door | $450 - $1,400 | A single panel sits at the low end, a framed door at the top. |
| Walls: PVC panels or tile | $1,100 - $3,900 | Panels finish in a day; tile adds days and takes any look you want. |
| Tear-out only | $450 - $950 | The tub gone and the alcove left clean for another trade. |
| Small job minimum | around $2,400 | Even the simplest swap books a licensed plumber and a full crew. |
Wall condition, drain position and the glass you choose move every line. The visit pins the figure down, and the figure then holds.
A bathtub drains at one end through its own trap; most showers want the drain nearer the middle, or along one edge when the plan is curbless. Sometimes the existing trap is close enough to reuse and sometimes it has to travel a foot or two, which means opening a strip of floor. We can usually tell which from the basement or the crawl space during the visit, and the paperwork you sign already names which one you are getting.
Houses older than the seventies like to add a surprise: galvanized supply lines rusted nearly shut, a cast iron trap that crumbles at a touch, or framing that got damp decades ago and kept it quiet. None of it is rare and none of it is ruinous, but it is your call, not ours. When something like that turns up, work pauses, you get photographs and a price for the fix, and nothing is billed until you have said yes to it. A conversion should never be the job where the invoice writes itself.
QIs losing the only bathtub a resale mistake?
AAgents repeat one rule: a family house shows better with a tub somewhere in it. If this is your only tub and small children are in your plans, we put that on the table during the visit and you decide with open eyes. If another bathroom keeps its tub, or the buyers you expect are shower people, the argument evaporates.
QHow long do we go without washing?
AThe toilet and sink stay usable every evening, and the water is only off for stretches on day one. The shower itself is ready once the silicone cures, so figure on missing roughly three days of showers at home. Plenty of clients time the job before a weekend away.
QDoes all the old tile come off the walls?
AOn the alcove walls, yes, because the new waterproofing needs to start from the studs, not from forty-year-old grout. Tile outside the alcove stays put, and we cut a clean line where the two meet.
QCan the new shower use the tub drain?
AThe pipe itself is nearly always reusable; the position is the question. A low curb pan can often sit its drain within reach of the old trap. Curbless floors want a relocated or linear drain, and that difference is priced before demo, never discovered after.
QDo we need a permit for the swap?
AA like-for-like fixture swap usually rides on a simple plumbing permit, and moving the drain can add an inspection. We file whatever your jurisdiction wants and fold the cost into the written price.
QWhat if there is rot behind the tub?
AIt happens, mostly around the old tile flange. You get photographs the hour we find it, a firm price for the repair, and the choice to proceed or pause. The framing fix is usually a morning, not a remodel.
The map carries the geography; the link lists underneath spell out every town our crews can reach from this one.
One three-day job stands between this bathroom and its best fixture.
Get my free quote