Our McAdoo crew pulls the idle tub, keeps the alcove, and hands back a shower anywhere in Schuylkill County within days.
Written quote at no cost, one callback, no chasing afterwards.
If you want to swap your clunky old tub for a modern walk-in stall, you are in the right place to find quick answers. Transitioning your washroom setup can instantly make your daily routine much faster and incredibly safer.
Actually, many folks realize that they rarely use their deep soaking basins anymore. Stepping over a high porcelain barrier every single day starts to feel like a gymnastics routine as the years roll by. By swapping that old basin for a sleek walk-in enclosure, you reclaim valuable floor space and eliminate a major tripping hazard in one clean sweep.
On top of that, your morning routine gets a massive upgrade when you do not have to climb into a giant bowl just to get clean. This change makes your daily wash much more accessible for everyone in the household, from young kids to visiting grandparents. You will also notice that cleaning a flat pan is ten times easier than scrubbing grime out of deep, curved corners.
Naturally, this upgrade boosts the overall look of your home without requiring a full down-to-the-studs remodel. You get a fresh, open layout that makes even the smallest washroom feel twice as large as before. It is a smart move that combines daily convenience with a major aesthetic upgrade.
This lets you enjoy a much more open washing area where you can actually stretch your arms without hitting cold plastic curtains. We install sturdy slip-resistant bases that keep your feet planted firmly on the ground. You can see the main differences between the old setup and the new style in the table below.
| Feature | Old High-Wall Basin | Modern Walk-In Setup |
|---|---|---|
| Entry Height | 15 to 18 inches | 3 to 5 inches |
| Maintenance | Hard scrubbing required | Easy wipe-down surfaces |
| Safety Level | High slip hazard | Low-profile, secure footing |
| Visual Space | Cramped and bulky | Open and bright |
Which means you can finally stop worrying about slipping on wet, curved porcelain surfaces. We customize every single installation to match your exact wall dimensions perfectly. This ensures a watertight seal that keeps your subfloor safe from hidden rot and mold.
Additionally, we can add built-in seating and sturdy grab bars that blend right into the design. These features offer immense peace of mind for anyone looking to age in place gracefully. You get all the utility of a safer washroom without sacrificing the modern look you want.
Now, you might worry that your entire home will turn into a dusty construction zone for weeks on end. Fortunately, our local team works incredibly fast because we focus specifically on this single type of washroom transformation. We usually complete the physical swap in just a couple of days, meaning minimal disruption to your household schedule.
First, we carefully extract the old iron or acrylic basin without damaging the surrounding wall framing. After that, we inspect the underlying pipes to ensure your plumbing is in tip-top shape before we seal everything up. If we find any old, leaky iron pipes, we replace them with modern, durable materials right then and there.
Then, we install the new low-profile pan and beautiful, low-maintenance wall panels. These non-porous materials resist mold growth, meaning you can throw away your harsh chemical scrubbers. Finally, we seal all the joints with high-grade silicone to guarantee a lifetime of leak-free performance.
To give you the best experience, we offer a massive variety of wall designs and hardware finishes. You can choose panels that look exactly like expensive stone tile without having to clean dirty grout lines ever again. This gives you the ultimate combination of luxury styling and effortless maintenance.
Besides the walls, you can select gorgeous glass doors that slide open smoothly or swing out on heavy-duty hinges. If you prefer an even more open look, a simple barrier-free threshold works wonderfully with a weighted curtain. This flexibility lets you tailor the space to your specific physical needs and design preferences.
Furthermore, we install recessed shelving units directly into the wall panels to hold all your shampoos and soaps. This keeps your new washing area completely clutter-free and organized. You get a clean, streamlined look that rivals high-end hotels.
Because we are active right here in McAdoo, Pennsylvania, we understand the unique plumbing quirks of homes in our community. Whether you live in a classic home built decades ago or a newer property, we know how to handle the local infrastructure. Our team arrives fully prepared with the exact permits and tools required for your specific zip code of 18237.
Considering the local median household income of $34,727, we know that homeowners here appreciate real, lasting value for their hard-earned dollars. We do not believe in offering cheap, temporary fixes that will fail in a couple of years. Instead, we focus on providing high-quality, durable solutions that protect your home investment for the long haul.
Since our local population is around 2,380 residents, we treat every single client like our close neighbor. We take great pride in our reputation and rely heavily on word-of-mouth recommendations from folks right down the street. You will receive honest, transparent communication from the very first quick note to the final cleanup.
To help you get started on this exciting home improvement project, we offer completely free, no-obligation consultations. We will come right to your home, measure your existing space, and discuss all the design options that fit your budget. This lets you make an informed decision without feeling any high-pressure sales tactics.
So, why keep struggling with an outdated, unsafe washroom when a beautiful alternative is one click away? Our team is ready to help you design a space that brings back the joy of a quick, refreshing wash. Contact us today to secure your free quote and take the first step toward a safer, more beautiful home.
Count the baths your household actually ran last year. In most homes we visit, the honest number is somewhere between zero and three, and yet every single morning somebody swings a leg over fifteen inches of porcelain rim to stand up and shower inside a fixture built for lying down. The tub charges rent daily and works a few evenings a year.
Nothing dramatic follows from that. Nobody is in danger because a bathtub exists, and if long soaks are part of your week, keep the tub and enjoy it with our blessing. The case for the conversion is plainer: when the tub has become a shower tray with high sides, you are paying, in caution and in cleaning, for a feature you retired years ago.
The swap itself is smaller than most people picture. The supply lines, the drain and the alcove walls are already exactly where a shower wants them, which is why this is a job measured in days. We are not building a new bathroom; we are letting the one you have stop pretending it still gives baths.
The same alcove, photographed the way the week actually unfolds. Weather never delays this one; it all happens indoors.
Floors along the hallway get covered, the water goes off for a few hours, and the bathtub is cut free and carried out, tile flange and all. With the alcove stripped, the plumber moves the drain to where the new pan wants it and sets the new valve at shower height. By supper the room is bare, clean and ready.
The base arrives first: an acrylic pan set dead level on a mortar bed, or a sloped, waterproofed floor when the plan says curbless. Then the walls close in, either grout-free panels bonded in a single afternoon or backer board ready for tile. Everything from here on is watertight before it is pretty.
The glass panel or door is drilled, hung and plumbed straight, the trim goes on, and the silicone lines are drawn last. Silicone wants a day to cure, so the first shower usually happens the following morning, which is exactly how we schedule the walkthrough.
Both are real showers in the same alcove. The difference is the entry, and what has to happen under it.
| What you weigh | Low curb | Curbless |
|---|---|---|
| What stands at the entry | A tidy threshold about 3 to 4 inches tall | Nothing. The bathroom floor rolls straight into the shower |
| Cost, installed | The friendlier bracket, most jobs land here | Roughly a third to a half more, the floor is rebuilt |
| What the crew rebuilds | The alcove only; the bathroom floor stays shut | Part of the bathroom floor, sloped and waterproofed |
| Water containment | The curb and glass do the holding | The slope and a linear drain do the holding |
| Suits best | Straight swaps on a budget and upstairs bathrooms | Wheels, walkers, and anyone planning to stay put for decades |
Undecided is a fine answer on the form. The site visit settles it with a tape measure, not a sales pitch.
Removal
Cut free, hauled out and off to recycling, with floors and doorways shielded on the way. The loudest hour of the conversion, and it wraps before most jobs have begun.
Plumbing
Tub drains sit at one end; showers drain where the pan says. We move what needs moving and swap the old valve for a pressure-balanced one.
The base
A level acrylic pan for most swaps, a mortar-built sloped floor for curbless plans. Either way it is tested with water before anything covers it.
The walls
Grout-free panels go up in an afternoon and wipe clean forever. Tile takes longer, costs more, and looks like whatever you can imagine.
The glass
A fixed panel keeps things open and easy to clean; a hinged door closes the warmth in. Both are tempered, both are set dead straight.
The finish
Shelving, the hand shower, clean caulk lines and a walkthrough. We leave the cure time in writing so the first shower is not a gamble.
| The job | Usual range | Inside the number |
|---|---|---|
| Standard tub-to-shower conversion | $3,100 - $5,600 | Tub out, low curb pan, wall panels, new valve, glass panel. |
| Curbless conversion | $4,900 - $8,800 | The floor is rebuilt flush and sloped to a linear drain. |
| Glass: fixed panel or hinged door | $450 - $1,400 | A single panel sits at the low end, a framed door at the top. |
| Walls: PVC panels or tile | $1,100 - $3,900 | Panels finish in a day; tile adds days and takes any look you want. |
| Tear-out only | $450 - $950 | The tub gone and the alcove left clean for another trade. |
| Small job minimum | around $2,400 | Even the simplest swap books a licensed plumber and a full crew. |
Wall condition, drain position and the glass you choose move every line. The visit pins the figure down, and the figure then holds.
A bathtub drains at one end through its own trap; most showers want the drain nearer the middle, or along one edge when the plan is curbless. Sometimes the existing trap is close enough to reuse and sometimes it has to travel a foot or two, which means opening a strip of floor. We can usually tell which from the basement or the crawl space during the visit, and the paperwork you sign already names which one you are getting.
Houses older than the seventies like to add a surprise: galvanized supply lines rusted nearly shut, a cast iron trap that crumbles at a touch, or framing that got damp decades ago and kept it quiet. None of it is rare and none of it is ruinous, but it is your call, not ours. When something like that turns up, work pauses, you get photographs and a price for the fix, and nothing is billed until you have said yes to it. A conversion should never be the job where the invoice writes itself.
QIs losing the only bathtub a resale mistake?
AAgents around McAdoo repeat one rule: a family house shows better with a tub somewhere in it. If this is your only tub and small children are in your plans, we put that on the table during the visit and you decide with open eyes. If another bathroom keeps its tub, or the buyers you expect are shower people, the argument evaporates.
QHow long do we go without washing?
AThe toilet and sink stay usable every evening, and the water is only off for stretches on day one. The shower itself is ready once the silicone cures, so figure on missing roughly three days of showers at home. Plenty of clients time the job before a weekend away.
QDoes all the old tile come off the walls?
AOn the alcove walls, yes, because the new waterproofing needs to start from the studs, not from forty-year-old grout. Tile outside the alcove stays put, and we cut a clean line where the two meet.
QCan the new shower use the tub drain?
AThe pipe itself is nearly always reusable; the position is the question. A low curb pan can often sit its drain within reach of the old trap. Curbless floors want a relocated or linear drain, and that difference is priced before demo, never discovered after.
QDo we need a permit for the swap?
AA like-for-like fixture swap usually rides on a simple plumbing permit, and moving the drain can add an inspection. We file whatever your jurisdiction wants and fold the cost into the written price.
QWhat if there is rot behind the tub?
AIt happens, mostly around the old tile flange. You get photographs the hour we find it, a firm price for the repair, and the choice to proceed or pause. The framing fix is usually a morning, not a remodel.
The map carries the geography; the link lists underneath spell out every town our crews can reach from this one.
For the bigger map: county seat pages start at Schuylkill County; the statewide picture lives on Pennsylvania; the wider region is the Northeast; background reading sits on Wikipedia.
One three-day job stands between this bathroom and its best fixture.
Get my free quote