Across Cleburne County, bathtubs that retired years ago give way to showers built in their own footprint.
Written quote at no cost, one callback, no chasing afterwards.
Maybe you feel tired of climbing over that high, slippery ledge just to wash off the dust of a long day. Actually, replacing that deep, unused basin with a walk-in stall will instantly make your daily routine safer and much faster. This smart change gives you a modern space that feels twice as big without moving any walls.
Because your old basin takes up so much room, removing it lets you reclaim valuable floor space. Since our local team visits homes all over this beautiful region near the Little Red River, we know exactly how to handle the unique plumbing quirks of local houses. You can request a free estimate today to see how easily we can transform your space.
When you think about it, very few people actually have the time to sit and soak in a giant basin anymore. By choosing to swap that bulky fixture for a sleek, modern pan with glass doors, you gain a massive amount of physical freedom. This layout update makes your morning routine feel less like an obstacle course and more like a trip to a high-end spa.
On top of that, your safety should always come first. Slipping on wet porcelain is a major worry for folks of all ages, especially when balancing on one foot to get out. Which means a low-profile entry base eliminates that tripping hazard entirely and keeps you independent in your own home for years to come.
Naturally, cleaning becomes a total breeze after this swap. Old basins have deep corners and grout lines that love to collect mold and soap scum. By installing modern acrylic walls or seamless solid panels, you can wipe down the entire area in about two minutes flat.
Let us look at how these two setups compare so you can make the best choice for your home:
| Feature | Old Traditional Basin | New Modern Walk-In |
|---|---|---|
| Entry Height | 15 to 20 inches to step over | 3 inches or less (ultra-low threshold) |
| Cleaning Effort | High (scrubbing grout and deep corners) | Very low (wipe-down panels) |
| Floor Space | Cramped and bulky | Open and airy feeling |
First, our skilled technicians will visit your home to look at your current layout and take precise measurements. We need to check where your drain sits because moving pipes around can sometimes add unexpected costs. This initial visit is completely free and gives you a clear picture of what is possible.
Next, we carefully remove the old cast iron or fiberglass structure without damaging your surrounding walls. This step requires a lot of muscle and some real know-how to avoid messing up your existing water lines. Once the old beast is gone, we inspect the subfloor to ensure there is no hidden water damage or rot.
After checking the wood, we install the new leak-proof pan and connect it to your drain system. Then, we seal the walls with gorgeous, waterproof panels that look just like expensive stone but require zero maintenance. Finally, we mount your new fixtures and clean up every speck of dust before we leave.
If you want something that lasts a lifetime, high-tech acrylic is usually your best bet. This material resists scratches and chips, which means your new area will look brand new for decades. It also retains heat well, so your feet will not feel freezing cold when you step inside.
Another option is natural stone composite, which adds a gorgeous rustic charm to your cabin or suburban home. Although it costs a bit more, it offers incredible strength and a very premium texture under your feet. We can help you weigh the pros and cons of each material during your consultation.
Now is the perfect time to think about adding a rain showerhead or a sliding hand-held sprayer. These modern fixtures let you aim the water exactly where you need it, which makes washing your hair or rinsing the walls incredibly easy. You can even choose matte black or brushed nickel finishes to match your personal style.
Besides the faucet itself, we can install built-in benches, corner shelves, and heavy-duty grab bars. These features add incredible convenience and give you a sturdy place to rest while you wash. We make sure everything is anchored directly into the wall studs so they never pull loose.
Homebuyers these days are actively looking for modern, accessible bathrooms rather than outdated guest tubs. By upgrading your master bath, you instantly make your property much more attractive to potential buyers down the road. This project offers one of the highest returns on investment of any home improvement job.
Actually, many families living in Cleburne County, Arkansas, are choosing this exact update to help aging parents stay safe. With a local population of around 25,000 residents, keeping homes accessible is a growing trend across the state. Whether you live near Heber Springs or closer to the quiet state parks, we come right to your door.
Since the median household income in this scenic area is around $51,000, we understand the importance of budgeting carefully. That is why we offer transparent pricing and zero-obligation estimates to help you plan without any pressure. We serve multiple ZIP codes in the area, ensuring every neighbor gets top-tier service.
Trying to tackle a major plumbing tear-out by yourself can quickly turn into a total nightmare. One wrong turn of a wrench can flood your home and cause thousands of dollars in water damage. Hiring our experienced crew ensures the job gets done right the very first time without any stress.
We bring all the specialized tools, pull the necessary permits, and handle the heavy lifting from start to finish. Plus, we know how to properly seal every seam to prevent mold from growing behind your new walls. You can sleep easy knowing your home is protected by a solid warranty on both labor and materials.
If you are ready to stop struggling with your old bathroom, we are here to help you take the next step. Contact us today to request your free on-site estimate and let us build the washroom of your dreams!
Count the baths your household actually ran last year. In most homes we visit, the honest number is somewhere between zero and three, and yet every single morning somebody swings a leg over fifteen inches of porcelain rim to stand up and shower inside a fixture built for lying down. The tub charges rent daily and works a few evenings a year.
Nothing dramatic follows from that. Nobody is in danger because a bathtub exists, and if long soaks are part of your week, keep the tub and enjoy it with our blessing. The case for the conversion is plainer: when the tub has become a shower tray with high sides, you are paying, in caution and in cleaning, for a feature you retired years ago.
The swap itself is smaller than most people picture. The supply lines, the drain and the alcove walls are already exactly where a shower wants them, which is why this is a job measured in days. We are not building a new bathroom; we are letting the one you have stop pretending it still gives baths.
The same alcove, photographed the way the week actually unfolds. Weather never delays this one; it all happens indoors.
Floors along the hallway get covered, the water goes off for a few hours, and the bathtub is cut free and carried out, tile flange and all. With the alcove stripped, the plumber moves the drain to where the new pan wants it and sets the new valve at shower height. By supper the room is bare, clean and ready.
The base arrives first: an acrylic pan set dead level on a mortar bed, or a sloped, waterproofed floor when the plan says curbless. Then the walls close in, either grout-free panels bonded in a single afternoon or backer board ready for tile. Everything from here on is watertight before it is pretty.
The glass panel or door is drilled, hung and plumbed straight, the trim goes on, and the silicone lines are drawn last. Silicone wants a day to cure, so the first shower usually happens the following morning, which is exactly how we schedule the walkthrough.
Both are real showers in the same alcove. The difference is the entry, and what has to happen under it.
| What you weigh | Low curb | Curbless |
|---|---|---|
| What stands at the entry | A tidy threshold about 3 to 4 inches tall | Nothing. The bathroom floor rolls straight into the shower |
| Cost, installed | The friendlier bracket, most jobs land here | Roughly a third to a half more, the floor is rebuilt |
| What the crew rebuilds | The alcove only; the bathroom floor stays shut | Part of the bathroom floor, sloped and waterproofed |
| Water containment | The curb and glass do the holding | The slope and a linear drain do the holding |
| Suits best | Straight swaps on a budget and upstairs bathrooms | Wheels, walkers, and anyone planning to stay put for decades |
Undecided is a fine answer on the form. The site visit settles it with a tape measure, not a sales pitch.
Removal
Cut free, hauled out and off to recycling, with floors and doorways shielded on the way. The loudest hour of the conversion, and it wraps before most jobs have begun.
Plumbing
Tub drains sit at one end; showers drain where the pan says. We move what needs moving and swap the old valve for a pressure-balanced one.
The base
A level acrylic pan for most swaps, a mortar-built sloped floor for curbless plans. Either way it is tested with water before anything covers it.
The walls
Grout-free panels go up in an afternoon and wipe clean forever. Tile takes longer, costs more, and looks like whatever you can imagine.
The glass
A fixed panel keeps things open and easy to clean; a hinged door closes the warmth in. Both are tempered, both are set dead straight.
The finish
Shelving, the hand shower, clean caulk lines and a walkthrough. We leave the cure time in writing so the first shower is not a gamble.
| The job | Usual range | Inside the number |
|---|---|---|
| Standard tub-to-shower conversion | $3,100 - $5,600 | Tub out, low curb pan, wall panels, new valve, glass panel. |
| Curbless conversion | $4,900 - $8,800 | The floor is rebuilt flush and sloped to a linear drain. |
| Glass: fixed panel or hinged door | $450 - $1,400 | A single panel sits at the low end, a framed door at the top. |
| Walls: PVC panels or tile | $1,100 - $3,900 | Panels finish in a day; tile adds days and takes any look you want. |
| Tear-out only | $450 - $950 | The tub gone and the alcove left clean for another trade. |
| Small job minimum | around $2,400 | Even the simplest swap books a licensed plumber and a full crew. |
Wall condition, drain position and the glass you choose move every line. The visit pins the figure down, and the figure then holds.
A bathtub drains at one end through its own trap; most showers want the drain nearer the middle, or along one edge when the plan is curbless. Sometimes the existing trap is close enough to reuse and sometimes it has to travel a foot or two, which means opening a strip of floor. We can usually tell which from the basement or the crawl space during the visit, and the paperwork you sign already names which one you are getting.
Houses older than the seventies like to add a surprise: galvanized supply lines rusted nearly shut, a cast iron trap that crumbles at a touch, or framing that got damp decades ago and kept it quiet. None of it is rare and none of it is ruinous, but it is your call, not ours. When something like that turns up, work pauses, you get photographs and a price for the fix, and nothing is billed until you have said yes to it. A conversion should never be the job where the invoice writes itself.
QIs losing the only bathtub a resale mistake?
AAgents repeat one rule: a family house shows better with a tub somewhere in it. If this is your only tub and small children are in your plans, we put that on the table during the visit and you decide with open eyes. If another bathroom keeps its tub, or the buyers you expect are shower people, the argument evaporates.
QHow long do we go without washing?
AThe toilet and sink stay usable every evening, and the water is only off for stretches on day one. The shower itself is ready once the silicone cures, so figure on missing roughly three days of showers at home. Plenty of clients time the job before a weekend away.
QDoes all the old tile come off the walls?
AOn the alcove walls, yes, because the new waterproofing needs to start from the studs, not from forty-year-old grout. Tile outside the alcove stays put, and we cut a clean line where the two meet.
QCan the new shower use the tub drain?
AThe pipe itself is nearly always reusable; the position is the question. A low curb pan can often sit its drain within reach of the old trap. Curbless floors want a relocated or linear drain, and that difference is priced before demo, never discovered after.
QDo we need a permit for the swap?
AA like-for-like fixture swap usually rides on a simple plumbing permit, and moving the drain can add an inspection. We file whatever your jurisdiction wants and fold the cost into the written price.
QWhat if there is rot behind the tub?
AIt happens, mostly around the old tile flange. You get photographs the hour we find it, a firm price for the repair, and the choice to proceed or pause. The framing fix is usually a morning, not a remodel.
The map carries the geography; the link lists underneath spell out every town our crews can reach from this one.
One three-day job stands between this bathroom and its best fixture.
Get my free quote